I started having problems with the combined instrument and microphone connector in my two-year old Behringer Xenyx 302USB audio interface. The 1/4″ instrument plug connector was fine but the XLR connector for the microphone cable started to make loud cracking and popping noises when slightly moving the cable. At first i thought i need a new cable and i actually went into the local musical instrument store Pihlajamaan Musiikki Oy to buy a new cable but walked out with a new audio interface as well. When i got back home it turned out that the problem really was with the Behringer’s connector and not the cable.
I plugged in the Scarlett Solo and instantly noticed an improvement in the playback sound quality. The difference was noticeable with both the Behringer Truth B2030A active speakers and my Sennheiser HD650 headphones. I have been suspecting the audio output quality is not that good with the Xenyx and by having a new interface i could confirm my doubts. I don’t mean the Xenyx is really that bad but there are some minor glitches you can hear when turning the volume knobs such as the channel balance (Left/Right) altering slightly when adjusting the gain knobs and i also think that routing all the audio via the EQ faders just adds another component into the signal path altering the sound even though the faders would be set to zero. The Scarlett Solo sounds a lot more versatile and especially the high frequencies sound much clearer. The sound feels more neutral and transparent.
Focusrite Scarlett Solo 2nd gen pros and cons
- Good overall build and sound quality for a home studio
- Very nice software bundle. Especially the Time and Tone Bundle by Softube AB was a really nice surprise and definitely worth another post!
- Instrument inputs are difficult to overdrive and can handle higher sound levels with ease.
- No switch for selecting between the line out or headphone outputs. You have to power off your active speakers to listen with headphones only.
- Sometimes the Scarlett doesn’t power up when waking up my Mac from sleep mode and i have to unplug the USB cable to make it work again.
Scarlett Solo and the headphone output
So how does the Scarlett Solo perform with my Sennheiser HD 650 headphones which can be classified as high impedance (300 ohm) headphones with higher power requirement from the headphone output? To my experience this far – they do just fine. As with the Behringer, i can make these headphones sound way too loud even without cranking the volume knob up to the maximum level. In my usual listening volumes the volume knob position is somewhere between 9 and 12 o’clock. I also don’t notice any distortion or loss of ‘punchyness’ in the sound with higher volumes. I don’t think i need a headphone amp quite now but might try one some day to see if there really are any big differences.
I have to say that the Scarlett Solo was a really good purchase. If you need an interface with one XLR and one 1/4″ plug input with a selectable direct monitoring ability or if you just need a computer DAC to control your active speakers, the Scarlett Solo gives you a lot of value for the money.